Decon Force 100 (DF-100)
The Ultimate Solution for Illicit Drug and Hazardous Chemical Decontamination
Decon Force 100
The Ultimate Solution for Illicit Drug and Hazardous Chemical Decontamination Decon Force 100 is designed to tackle a wide range of hazardous substances, including methamphetamine, fentanyl, precursor chemicals, tear gas smoke and fire residues. This versatility makes it an ideal solution for contractors who face diverse contamination scenarios in residential and commercial structures.Neutralize Methamphetamine and Fentanyl Contamination with Confidence!
DECON FORCE 100
It’s based on technology originally developed and patented by scientists at Sandia National Laboratories. Artemis Bio-Solutions has been granted a license from Sandia (No. 00-C02678) to commercially manufacture this product for commercial and professional use.
This patented, advanced formula has been used successfully world-wide for over 10 years in every extreme situation you can imagine.
DECON FORCE 100 is formulated and tested to neutralize and remove residues from fentanyl, methamphetamine and the chemicals used to make them. When used as directed, Decon Force 100 offers professional remediators a safe, effective, and efficient way to neutralize and destroy these hazardous substances in residential and commercial buildings. Ensuring you pass clearance tests.
KEY FEATURES
Directions for Use
Fentanyl and Methamphetamine Decontamination
- Prepare three-part solution according to Mixing Instructions on Decon Force-100 container.
- Adorn Level C personal protective equipment (PPE) that is OSHA, NIOSH, and EPA-approved, including a Tyvek suit or similar hooded coverall, a full-face respirator with a P-100 broad-spectrum chemical filter, and chemical-resistant gloves and booties.
- Enter contaminated site and turn off HVAC unit(s), if applicable.
- Close all access points (e.g., windows, doors, etc.) to minimize air flow.
- Remove all HVAC vents and intake covers, if applicable. Remove and safely dispose of HVAC filter(s).
- Use a HEPA vacuum or vacuum with a HEPA filter and vacuum inside of all vent openings.
- Apply Decon Force-100 mixed solution via mechanical spray device, ULV sprayer, or foaming device to all surfaces with suspected contamination until ALL surfaces are visibly wet. This includes walls, floors, ceilings, fixtures (e.g., light fixtures, fans, window treatments, etc.), and cabinet interiors and exteriors. Surfaces should be wet but not saturated or with visible runoff.
- Using a fogging device, fog Decon Force-100 into the HVAC vents and HVAC intake.
- Exit area and allow applied solution to sit for 1 hour or until solution has settled, if fogged or sprayed.
- Reenter area in full PPE and repeat application with the solution as described in Steps 7 and 8.
- If HVAC is present, turn on HVAC fan on, and fog or spray solution into filter opening. Allow HVAC fan to run for 20 seconds before turning fan off.
- If applicable, pour two ounces of solution into each drain (sink, tub, shower, floor drain) to neutralize any residue that may remain in the drain’s P-trap.
- Exit treated area for a minimum of 8 hours.
- For severely contaminated areas, a third application may be required.
- After dwell time on final application has elapsed, ventilate the treated area. Post-treatment testing is highly recommended.
CONTACT FORM